Possibility to start the circulation pump for warm water for e.g. 5 min? #549
-
|
Hi everyone, is it possible via BSB LAN to let the circulation pump run for a certain amount of time? I'd like to trigger the pump e.g. via a switch in case I need warm water and otherwise keep the circulation off. Thanks! |
Beta Was this translation helpful? Give feedback.
Replies: 1 comment
-
|
Such time-based functions could potentially be implemented using BSB_LAN_custom.h, but I'm not sure whether you can directly start and stop the circulation pump via BSB-LAN. You would have to see if there is a parameter on the heater that allows for that, and if there is, you can do it via BSB-LAN, but if there isn't, then there's nothing you can do about it. |
Beta Was this translation helpful? Give feedback.
Such time-based functions could potentially be implemented using BSB_LAN_custom.h, but I'm not sure whether you can directly start and stop the circulation pump via BSB-LAN. You would have to see if there is a parameter on the heater that allows for that, and if there is, you can do it via BSB-LAN, but if there isn't, then there's nothing you can do about it.